Pump and motor questions
Short answers from the workshop. Not finding yours? Ask on WhatsApp or send a service request.
മലയാളത്തിൽ വായിക്കുകWhy does my submersible pump trip?
Usually because the motor is drawing too much current — a jammed impeller, a weak capacitor, low voltage or water inside the motor. Switch it off and do not keep resetting it, because repeated tripping can burn the winding; send us a video from the service page and we will tell you the likely cause.
The motor runs but no water comes out. What is wrong?
Common causes are a worn or broken impeller, a blocked strainer, a leaking pipe joint or the water level dropping below the pump. We check the pump on the bench and tell you which part has failed before replacing anything.
What does motor rewinding cost in Kozhikode?
It depends on the motor's HP, whether it is submersible or surface, single or three phase, and how much copper wire it needs. We check the motor and give you a fixed quote before starting — send a photo of the motor's nameplate on WhatsApp for a first idea.
Should I rewind my motor or buy a new one?
If the body, shaft and bearings are in good condition, rewinding is usually cheaper than a new motor. If the stator core is damaged, we will tell you that replacing it is the better choice.
Which mechanical seal fits my pump?
It depends on the seal type and the shaft size in millimetres — for example, a Type 21 seal for a 16 mm shaft. Use the part finder with your pump's brand, series and HP, or send us a photo of the old seal.
My motor hums but does not start. Is it the capacitor?
Often, yes — a weak or failed capacitor is the most common reason a single-phase motor hums without starting. Check the µF and voltage printed on the old capacitor and buy the same rating; if a new capacitor does not help, the motor needs checking.
Do you sell submersible cable and winding wire loose?
Yes. Submersible flat cable is sold by the metre in half-metre steps, and copper winding wire is sold by weight. You can order online or buy at the counter.
Where can I get my Tormac pump serviced in Calicut?
At Thambi Electrical Engineering, 14/70 CI, behind Indo Electricals, Francis Road, Chalappuram — an authorised service centre for Tormac Pumps. Bring the pump with its purchase bill, or call 93494 95703 first.
How do I send you my pump problem?
Open the service page, choose the symptoms, add a short video and up to four photos, and send it. You get a tracking link and we reply there with advice, a part or a quote.
Is this shop connected to other shops called Thambi?
No. Thambi Electrical Engineering in Chalappuram, Kozhikode is not connected with similarly named shops in other places. Our only address is 14/70 CI, behind Indo Electricals, Francis Road, Calicut 673 002.